- Version with the addition of the slitting module
- Easy retooling - operates on the basis of DES
- The mechanism is equipped with a system for precise measurement
- Dedicated for the CTCM S-line 4OOO
To ensure the best cut quality and at the same time meet the broad spectrum of requirements, we recommend the latest machine in the CTCM 4OO+ series
The CTCM 4OO+ is an advanced device designed for automatic cutting of corrugated tubing in the perpendicular plane to the axis of the tubing, in the place of the largest diameter (on the crest).
It works on the basis of the DES (Diameter Exchange System).
The DES system allows the operator to easily and efficiently set up the machine, making it possible to cut corrugated tubing of any diameter in the range from NW 4.5 to NW 42mm using the same CTCM 4OO machine. The DES system is dedicated to the specific corrugated tubing size.
The machine is an upgraded version of CTCM 4OO, with the addition of a module for slitting.
The feed speed is controlled by the operator.
Modifications made in the design of the machine allow for significantly increased rate of placing the material in the device.
In the CTCM 4OO+ continuous quality is guaranteed by a system of sensors and precise measurement, which supervise the work of the machine.
The certainty that cut on the crest will be performed at the highest level is guaranteed by the patented DANROB corrugated tubing positioning system.
CHECK THE TENSION OF TUBING FEED BELTS
CHECK THE CONDITION OF TUBING FEED BELTS
CLEAR THE PLEXIGLASS COVER AND CHECK FOR DAMAGE
CLEAN MACHINE COMPONENTS WITH COMPRESSED AIR OR SOFT BRUSH
CHECK, IF NECESSARY LUBRICATE THE KNIFE CART
CHECK THE KNIFE CONDITION
CHECK THE OPERATION OF PNEUMATICS
CHECK THE CONDITION OF ELECTRICAL CONNECTIONS
MAKE SURE THAT THE DEVICE IS STABLE ON THE GROUND AND GUARANTEES SUFFICIENT STABILITY WHEN INSERTING AND CUTTING TUBING
GREASING THE LATCHES AND BLOWING THROUGH THE DES MODULE
Every 2 weeks